Our bump stop kit is the perfect solution for anyone running stock LCAs with cut-and-weld knuckles. Depending on your alignment, there’s usually a fine line between the tie rods over-centering at full lock and staying safe. Sometimes you can get away without bump stops, but with this kit, you can be sure you’re dialed… and it’s easy to add and remove plates if you need to.

Each kit includes two plates per side so you can fine-tune your angle. Installation is simple: cut off your factory bump stop with an angle grinder and hit the area with some paint. Turn to full lock and place a plate against the arm where the outer tie rod makes contact, centered between the two holes. Hold it in place, turn the knuckle away, mark and drill your holes, bolt it up, and you’re done.

Kit contents:
4x Stainless Steel Plates
4x Flat Head Screws
4x Washers
4x Lock Nuts